For installation of tile the tile ends at each control joint and the gap if filled with caulk rather than grout.
Ceramic tile over expansion joints.
An anti fracture membrane should also be used under the tile to minimize the chance that cracks in the slab will telegraph through to the tile.
Recognizing that tile is a facade movement joints are needed to eliminate stresses that can occur between the substrate and the tile due to differing amounts of expansion and contraction.
Where should movement joints be placed.
An expansion joint is in the substrate for instance in concrete.
A movement joint is in the tile only.
The tcna handbook recommends allowing for expansion and contraction in every tile installation.
It s quite common to see controlled breaks in concrete and those are usually expansion joints.
One of the most basic and important facts an installer should know when working with ceramic including porcelain glass and natural stone tile is to always have expansion joints in place.
Tile over expansion joint no membrane or installation system is designed to bridge any joint with verticle displacement.
If you tile over an expansion joint then you need to honor that joint in the tile as well.
If expansion joints are not part of the installation failure is lurking in the shadows waiting to strike.
It allows for movement in the tile.
1 8 movement with any sheet system typically and 1 16 with a few trowel on systems.
The short answer is that you do not span control expansion joints with the tile.
Control joints are there because it s not a question of if the slab will crack but rather when the slab cracks it hopefully happens at the joint.